Wan 2.2 GGUF Workflow I2V with Upscale

This workflow is my take on organizing and building an I2V model running against a "smaller" graphics card (specifically 12 GB). I use Q5 GGUF models, though I have also tested against smaller Q4 and Q3 - each having a slight decrease to prompt adherence and quality, but still usable. This includes using the lightspeed lora and notes on where all models / loras can be downloaded from.

I suggest if you have limited RAM or VRAM, to run ComfyUI with the parameter: --cache-none

While this will mean multiple batches against the same video will be slower, you get a much more consistent overall generation speed of your videos (3-4 minutes for 5-6 seconds on moderate home PC configurations).

This also includes using Florence2 (LLM) for image detection and auto-prompt assistance. You only need to add your action to the manual prompt (if desired).

There are a lot of nodes I have seen in various workflows ... but in Wan 2.2 I2V, at least, they tend to have no effect and only increase overhead.

I run my videos typically in 480p @ 480 x 832, and this workflow then upscales by 2x to 960 x 1664.

Custom Nodes Used:

ComfyUI-GGUF ( ( ( ( ( Node Suite (